'00 marzocchi monster T question...

Printable View

10-27-2006, 08:31 PM
Choke Slam

'00 marzocchi monster T question...

...the stanchions have a butted/thinner section where the lower crown would bolt on. Does the lower crown need to stay in the thinner section, or can the crown be half on/half off the thin section? The thing that makes me wonder about this is that it is an abrupt change from thick to thin, and is about 0.5mm deep. I looked at the owner's manual for a '00 and a '01, and the only thing close to describing the location of the lower crown is that it must be at least 178mm from the tire. The part that sucks is that when I have the crown where I want, then the ridge of the thick/thin section of the stanchion is in the middle of the lower crown. Basicaly, I don't want to break the crown, stanchion, or myself in the process if I put the crown where its not supposed to be. Any thoughts?
10-27-2006, 08:48 PM
marshalolson

paging kidwoo & vicious
10-27-2006, 09:40 PM
MarsB

I would also post this on ridemonkey.com on the DH page.
10-27-2006, 09:42 PM
marshalolson

how much overlap in mm is there on the stanction? what rim? maybe something wider to make the tire flatter?
10-27-2006, 10:07 PM
Choke Slam

with 180mm of clearance between the tire and crown, the ridge is about 5mm from the top of the lower crown. If the ridge is flush with the top of the lower crown, there isn't enough clearance between tire and crown. What do you think about a little PBR shim-ery?
10-27-2006, 10:09 PM
marshalolson

is it with a singletrack/2.8?
10-28-2006, 12:07 AM
Choke Slam

Quote:

Originally Posted by marshalolson

is it with a singletrack/2.8?

Its with the 2.8 michie, but I can't remember which rim Pete has. Its as wide as a singletrack. I searched on ridemonkey, but couldn't find anything for the '00. On a '03(I think, maybe '02) a guy was talking about not having the lower crown too far down and out of the reinforced area of the stanchion. If anything on the '00 the thicker part would be stronger. I'm just surprised that the owner's manual doesn't mention anything about the ridge. :confused:
10-28-2006, 10:38 AM
marshalolson

it looks like marz. rec a 567.8mm center of axle to top of crown distance on those... see where that lines up...
10-28-2006, 05:30 PM
Choke Slam

Quote:

Originally Posted by marshalolson

it looks like marz. rec a 567.8mm center of axle to top of crown distance on those... see where that lines up...

I'll check it out when I get home tomarrow. Thanks for the info, Brah.