Can you use any epoxy with a Fischer carbon air core?
For screw pullout.
Printable View
Can you use any epoxy with a Fischer carbon air core?
For screw pullout.
sure, I have not seen the epoxy vs foam problems
I have a similar problem
I have a pair of scarch BC's with a "hybrid" core (foam and some other shit). They have been drilled 3X and had a bit of a delam under the heel from a bad mount job.
Anyway I fixed the delam with some plastic weld epoxy by drilling some tiny holes in the top skin and injecting epoxy directly into the core, flexed the skis a bunch and then clamped until cured. All mount holes were also injected with epoxy.
My question now is do I mount what ever binders (planning on freerides) directly to the ski or do I mount a plate over the old holes and then mount the binders to the plate? I wouldn't mind any extra weight or stiffness added by mounting the plate. just not sure about mounting screws into epoxy, especially if it is close to old mount holes.
mount directly and try to keep the new holes 1cm apart
thats what I was thinking but there are a lot of holes to try and miss.......