Trouble printing whole Naxo template

[charlesj]

After some searching I found the pdf for Naxo mounting template. When I print (at 100 percent of course) I get the middle. I tried rotating 90 degrees and that did not help. I thought cropping it into 3 parts would work but was not able to do that (preview did not permit it). I have a vintage mac iBook, an HP printer and I was using preview. Yes, I must be clueless. Does anyone have a clue? Thanks

This is the link to pdf:

http://www.naxo.ch/downloads/prodInf...e_naxo0607.pdf

[Eldo]

That template obviously won't fit on letter size paper, so I assume you are printing to legal size paper?

Make sure the page size and direction are set up properly in "page setup" before going to print.

Otherwise I'm not sure what the problem would be.

[charlesj]

It won't fit on either letter or legal. There must be some way to have it print out to 3 pages then I can physically cut and paste. In other words I need to crop or cut the image, print, then reassemble. The only obvious (to me) solution is to scale it, then enlarge it to the right size, using the middle section, at 100 percent, as a reference. I would rather not do that as reducing and enlarging might cause some scaling and resolution issues.

[Mechmaster]

In Acrobat, try zooming into the area you want to print (using the zoom tool).

Click Print. In the resulting window:
Print Range --> Current View
Page Scaling --> None
Auto-Rotate and Center --> <selected>

Zoom in the general vicinity of each of the three pages and you should be good to go.