Where's the Forward Pressure screw? P12 Demo...pic inside

[frank828]

someone help me out. I dont see any other screw other than the DIN screw

[bossass]

There is no forward pressure screw on the the Pivot demos.

If I recall correctly, there's hash marks on the top of the tab you pull to move the heel piece. There should be some sort of arrow or mark outside of that hashed tab. The arrow should be within the hashed area for correct forward pressure. As I remember, to achieve this the heel of the boot had to almost not clear the front of the heel piece--like you would think you would need to move the heel back (make it bigger) one notch. You had to just jam your heel in there and that would be correct.

[frank828]

i moved the tab to the point of barely have 1-2mm of space between the boot and the heelpiece. It seems like its ok and everything clicks in. Do you think i dont have to worry about it now?

[corn dog]

Looking at a couple of other related demo bindings, px12 demo and I thinks its a nova, they both have a little window somewhere on the heel. The px12 seems to have a yellow piece that you want to move so that you've got half yellow half white in the window, the other has a black line that appears inside some hash marks. But yeah if you can barely squeak the boot down into the heel piece it'll be right.

[bossass]

i moved the tab to the point of barely have 1-2mm of space between the boot and the heelpiece. It seems like its ok and everything clicks in. Do you think i dont have to worry about it now?

I don't know. I always had to have it where it looked like the heel wouldn't clear the heel piece by 1 or 2mm. Make it one smaller, if you can't get the boot in, than revert to the one you have it at now. Do you see these hash marks I describe?

[frank828]

i dont have the bindings in from of me right. I have the rear set to the closest it can get till its too small get the boot in.

I think im ok...i hope