Look Bindings - Adjusting Heel Piece - Forward Pressure?

[Below Zero]

I got my Little Big Fats back from warranty and re-mounted my Look Pivot Jib bindings.

The one thing I am confused about is how far forward (forward pressure is the term, correct? - JONG!) do I adjust the heel piece in relationship to the boot heel.

You can see on my boot heel where the "prongs" on the look binding heel piece have made a slight impression into the boot heel. I have adjusted the binding so the "prongs" hit in this same spot again.

So what is the correct way to adjust these?

[ScottG]

Adjust rear screw until screw is flush with the bottom of the scooped out indent when boot is in binding.
that is correct forward pressure.

[bossass]

Adjust rear screw until screw is flush with the bottom of the scooped out indent when boot is in binding.
that is correct forward pressure.

I concur.

[gwat]

I concur.

^^ What he said.

[The Jackamo]

^^ What he said.

i second this motion.

all in favor say 'aye'

[summit]

aye4567890

[gwat]

Motion passed.

[Duker]

Paper signed.

[crashnburn'd]

wait!!!

....

[Dug]

Just wanted to reconfirm: Flush with the indent above the screw or below the screw, or maybe even right in between the two?

[enzo3366]

it should be flush with the bottom of the semi-circle indent above the screw

afterwards, click the boot in and out a couple of times to make sure the screw is indeed flush with the indent above the screw.

[Dug]

Awesome, thanks!