"Custom" binding mounting plates

[Arnoldtheskier]

Hello..heard that someone out here would know this.Where can I get plates/adaptors..ideally.. drilled so that I can both screw them onto my "Autodrive"(Dy./Look)plate..AND with a Sol. pattern..so that I can slap them on?.A blank would be ok too.I came across these ONCE in an add..that said.."Autodrive plate..with adaptors"..Of COURSE! can't find it.If they can't be had..OR are too expensive..then I guess I gotta do the old " have drill press..get stock..MAKE MYSELF"..THANKS! for ANY help..

[CaddyDaddy77]

I haven't seen a blank for the autodrive, with the exception of using some of the older plates. 01-02?
It's possible you could use a thin
VIST Plate and screw it into the existing plate. There is both pre-drilled and blanks available.

Looks like youv'e been looking for awhile, huh? Good luck.

Also might try getting ahold of the guys at racer's edge in Breck, they are pretty creative.

[Arnoldtheskier]

Thanks! for your help..lol..NAaaa..I haven't been REALLY looking around that much..just that I came across these Dinosaurs..I LIKE!! Dynastars..they were simply TOO good a deal to pass up..I ALREADY knew about the propriety plate(Look) thing..being basically of the NON-integrated mentality(MENTALLY UNFIT)..whereupon..I think in neanderthal terms..you know.."These are MY skis..DON'T be givin me none of that jive ass..I'll put WHATEVER F***** bindings I WANT ON MY SKIS" okokok..I am TOO cheap to cough up a couple yards for the "right" bindings.I mean WHAT is REALLY more important..2 seconds screwing bindings on..OR fiddling around making plates and telling the ski and binding companies to SHOVE IT..Sure.APPARENTLLY MANY skiers!! have done just that.Witness the number of skis/plates that are NOW AVAILABLE with blanks.
I have a Sal.jig..NOT the Look..I figger if I gotta measure..drill the thing to screw it onto the Autodrive..I MAY as well do the whole thing..ya..I have some Derb's,Rossi,Ty Plates about..I could scab one of them..but then..the blank stock is only $15 Cdn for me..just thought that I MIGHT find the plates I want ALREADY done..and oh yeah..cheeeep...
My end goal..is to spend WAY,WAY more time fiddling around..when I could be/should be WORKING..so that I could either have done this/had it done..BOUGHT the Looks..I WANT this plate/adaptor thing to be worth THOUSANDS!..HEHEHAHA...
Thanks man..

[Spamhelmet]

Ahnold, you really should cut down your amphetamine use.

Really.