Check Out Our Shop
Results 1 to 6 of 6

Thread: Epoxy / Delam question

  1. #1
    Join Date
    Oct 2004
    Location
    Summit Park UT
    Posts
    1,163

    Epoxy / Delam question

    I have some skis with tail delams, so I epoxied them. However, apparently my epoxy has gone bad or I mixed it up poorly because after 36 hours it is still gummy, even the stuff I mixed up on cardboard. So I am assuming its going to fail. When it does, how do I get all the bad epoxy out of there without worsening the delam? Do I just scrape out as much as I can with a pick and call it good?

  2. #2
    Join Date
    Oct 2004
    Location
    Summit Park UT
    Posts
    1,163
    anyone???

  3. #3
    Join Date
    Oct 2006
    Posts
    156

    Epoxy repair.

    Your probably better off doing the repair now especially If the epoxy on the cardboard is still soft. The good part is the epoxy inside the delam maybe even softer(easier to clean up). Unfortunately you may delam it a bit further when cleaning it up properly(to get a good bond it is very important to remove all of the fucked up existing epoxy). I'd personally heat up the affected area with a heat gun to further soften the partially set epoxy pry the delam open and start scarping it out with a razor-blade/utility knife once you've removed the bulk of the epoxy then use strong solvent like acetone to clean up the two surfaces prior to re-epoxying the delam. Be sure to get some new epoxy and take the time to mix it carefully. Hope this helps.

    -CamD

  4. #4
    Join Date
    Dec 2004
    Location
    wherever my car takes me
    Posts
    1,718
    Between which layers are the delam?

    What kind of resin did you use?
    Quote Originally Posted by wintermittent
    And furthermore. What is up with turkey bacon? Healthy bacon? Unpossible.
    Quote Originally Posted by snowsprite
    That is like masturbation. People resort to it when they can't have the real thing!

  5. #5
    Join Date
    Oct 2004
    Location
    Summit Park UT
    Posts
    1,163
    Its the base that delammed. The epoxy was just some Ace Hardware long cure stuff (maybe that wasnt a good idea?). Is this acetone idea safe? Any particular brand or type of epoxy people reccommend?

  6. #6
    Join Date
    Sep 2004
    Location
    LV-426
    Posts
    21,758
    In case you're doing this work outside or in the garage --

    when you finish your epoxy repair, and have it all cleanly clamped together, bring it inside for a day so that the epoxy can cure in warm temperature.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •